vihtavuori n555 Options
vihtavuori n555 Options
Blog Article
The graph on the 1st page of that topic need to convince you that Alliant 410 isn't the powder to implement with AA-HS hulls.
The balance is for powder. Considering the fact that your crimp goes in the wad column/hull your powder isn't bulky more than enough which lets the shot/wad column to established much too deep within the hull. Because you have intense constraints with component availability inside the 410 gauge its likely necessary to adjust powder in an effort to resolve the issue.
When you seeking to slow the shell down to beneath 1300fps (why I don't know, as it just causes the pattern to hot spot center), then 296/H110 will be the best powder, as it could have a rather cleaner burn as an alternative.
Also, you should definitely established the crimper up to crimp into the depth of a few dime, and ensure that you are only somewhat taper crimping the hulls.
Absolutely sure really have to agree with this particular dialog that the modern 410 powders just will not be an improved propellant. I have attempted these more recent types as well and 296 remains to be the way to GO!
If That is your initial visit, you'll want to check out the FAQ by clicking the hyperlink over. You may have to sign-up prior to deciding to can write-up: simply click the sign-up backlink earlier mentioned to carry on.
So 296/297 at 1200fps leaves many unburnt powder from the bore, whilst the faster/higher Performing tension loads real winds up with fewer unburnt powder inside the bores isntead.
If That is your first take a look at, be sure you check out the FAQ by clicking the url higher than. You will have to sign up prior to deciding to can write-up: simply click the sign up connection previously mentioned to carry on.
Confident should agree using special info this type of dialog that the new 410 powders just usually are not an improved propellant. I've experimented with these newer types way too and 296 remains to be the best way to GO!
Rays Gunstock Services; has considerable experience in gunstocking and gunsmithing. Now restricted to stock work on shotguns, as well as restoration of shotguns. Some duplication support can be available.
WARNING: This products can expose you to guide, which is known into the State of California to lead to cancer and birth defects or other reproductive hurt. For more info head over to – .
I just applied my previous pound of Alliant 2400. The one thing which i can discover offered that has any semblance of a gradual burning pistol powder is Alliant 410.
Though I haven't tried using it I agree with your pondering over a four ball load, sounds like the exact same challenge as I Formerly mentioned which has a five pellet load of OOO buck.
If The rationale that you will be swapping powders is due to the migration problem of the good ball powder making it way visit their website previous the seal and clogging the device, John and I have come up with powder form seals that correct the issues while in the PW devices, and the look could be converted more than on the Spolar devices at the same time.